Table of Contents
Advertisement
DX-80/120 Cordless Phone User Guide
REGISTERING YOUR PHONE
Registration programming allows you to register the handset to the
base unit after it has been installed by your system installer.
1) Be sure the handset you are registering is close to the base
(within a maximum of three feet).
To enter the Registration Mode:
2) Turn off (up) dip switch 1.
3) Turn on (down) dip switches 2 and 3.
• The down position is on, the up position is off.
4) Power on the base unit.
• After 5 seconds the system enters the registration mode.
• The LED on the base flashes quickly when the base is in
registration mode.
5) Press and hold the F1 soft key on the handset for a
minimume of 2 seconds to enter the System Programming
mode.
• Once you are in System Programming mode, the following
appears on the display:
6) Press the F1 (up) or F2 (down) soft key to select the
registration mode and display the following:
7) Press F3 (OK) key to enter registration mode and display the
following:
8) Press the F1 or F2 key to display the following:
NOTE
If the handset has not been registered, the LCD
displays a message requesting that you
Please Register
"
".
>LANGUAGE
REGISTRATION
>REGISTRATION
DE-REGISTER
>REGISTRATION
>REGISTRATION
Registering Your Phone (continued on next page)
NO?
YES?
- 5 -
O
VERVIEW
Advertisement
Table of Contents
