JUKI DDL-9000B Instruction Manual page 5

6
9
!1
!2
!0
8
!6
7
4
!1
!3
!2
!2
7
!4
2.0 to 3.5 mm
!5
!7
6) Fit knee lifter pressing rod 6 . Fit hinge 7 nto
the opening in the machine bed, and fit the
machine head to table rubber hinge 8 before
placing the machine head on cushions 9 on the
four corners.
7) Securely attach head support rod !0 to the table
until it goes no further. Regarding the control
panel !1 , remove two side plate fixing screws
!2 , place the rubber packing !3 , which is one of
the accessories of the control panel !1 , between
the head section and control panel !1 , then fix
them together.
(Caution)
1. Do not use the screws supplied as accesso-
ries of control panel !1 .
2. Be sure to mount the machine head support
bar on the machine table so that its height
from the table surface becomes 55 to 60 mm.
For the sewing machine provided with the AK
device, be sure to mount the support bar on
the table so that its height from the table sur-
face becomes 38 to 43 mm.
8) Bundle cable clip band !4 supplied as accesso­
ries of the machine head at the root of the cable.
9) Check to be sure that the table and the safety
switch arm !5 are engaged with each other by 2.0
mm to 3.5 mm, with the sewing machine slightly
tilted.
(Caution) If the engagement between the table and
the safety switch arm is 2 mm or less, Error
302 may occur at the time of startup. Or, if the
aforementioned engagement is 3.5 mm or more,
safety switch arm !5 may break.
10) If the engagement between the table and safety
switch arm !5 is outside the range of 2.0 mm
and 3.5 mm, loosen safety switch mounting
screw !6 and tilt safety switch !7 in the direction
of the arrow to adjust the engagement of safety
switch arm !5 with the table.
– 3 –