Daikin BRC1E61 Operation Manual page 10

1. Operation mode selector button
● Press this button to select the operation
mode of your preference. (See page 14.)
* Available modes vary with the connecting
model.
2. Fan speed control button
● Press this button to select the fan speed of
your preference. (See page 15.)
* Available fan speed vary with the
connecting model.
3. Menu/Enter button
● Used to indicate the main menu.
(See page 24 for the menu items.)
● Used to enter the setting item selected.
4. Up button (Be sure to press the
part with the symbol
● Used to raise the set temperature.
● The next items on the upper side will be
highlighted.
(The highlighted items will be scrolled
continuously when the button is kept
pressed.)
● Used to change the item selected.
5. Down button
the part with the symbol
● Used to lower the set temperature.
● The next items on the lower side will be
highlighted.
(The highlighted items will be scrolled
continuously when the button is kept
pressed.)
● Used to change the item selected.
6. Right button
the part with the symbol
● Used to highlight the next items on the
right-hand side.
● Each screen is scrolled in the right-hand
direction.
● Home leave settings are enabled with this
button kept pressed for at least four
seconds. (See page 19.)
English
)
(Be sure to press
)
(Be sure to press
)
7. Left button
the part with the symbol
● Used to highlight the next items on the
left-hand side.
● Each screen is scrolled in the left-hand
direction.
● Home leave settings are enabled with this
button kept pressed for at least four
seconds. (See page 19.)
8. On/Off button
● Press this button and system will start.
● Press this button again and system will
stop.
9. Operation lamp (Green)
● This lamp lights up during operation.
● This lamp blinks if a error occurs.
10. Cancel button
● Used to return to the previous screen.
11. LCD (with backlight)
● The backlight will be light for approximately
30 seconds by pressing any operation
button. Operate buttons excluding the On/
Off button while the backlight is lit.
● If two remote controllers are used to control
a single indoor unit, the backlight of the
remote controller operated earlier than the
other one will be lit.
(Be sure to press
)
9