Electrolux W465H Service Manual page 91

The door lock unlocks the door
The programme unit requests door unlocking by applying 0 V on input X92
3
of the door lock controller.
The following check is made prior to unlocking of the door:
• No water in drum - input "Level" from level guard B2 is closed = 0 V
• Drum not turning - pulse frequency on input "Tacho" from rotation
sensor B3 is less than 0.4 Hz.
When the above conditions are met, the door lock controller outputs an
opening pulse on output D0 to the door lock actuator/coil, which then
unlocks the door. Micro switches S4a and S4b now interrupt the actuator/
door lock and the I/O card 1 relays lose all voltage to prevent the motor
from starting (interlock signal on motor controller input X302). The drain
and water valves of the machine are now disabled and the heater and mo-
tor cannot be switched on.
3
5
E1 – E3
6
K21
14
Door and door lock
9
7
M1
8
1. Program unit A1
2. Temperature sensor B1
3, Level switch B2
4, Level switch B4
5. Display A2
6. Heater element E1 -3
7. Motor control U1
1
10
8.
9.
10. Voltage unit A5
11.
12.
13.
14.
2 3 4
11
12 13
Rotation sensor B3
Door lock module A41
I/O board
Watervalves
Drain valve
Power supply PSU
91
6659