Electrolux W465H Service Manual page 28

28
Fault code 09, KLIXON
This fault code is generated by the programming CPU board. The fault
code means that the temperature in the motor has been so high that the
klixon breaker in the motor has been triggered. It can be caused by over-
loading the motor due to an overloaded drum, low rpm for long periods,
defective klixon breaker in motor, short in cable between motor and CPU
board, etc.
Fault code 09, DRUM OVERFILLED
(only in coin operated machines)
This fault code is generated by the programming CPU card. The fault code
is caused by the mechanical level control in the machine, by safety reason
a doubled level system. The fault code arises if the drum has been filled
with water above a level that normaly should have generated fault code 07.
It can be caused by a blocked level hose, drops of water in the level tube,
defective filler valve, defective electronic filler control, etc.
Action: see fault code 07.
Fault code 10, DRUM NOT DRAINED
This fault code is generated by the programming CPU card. The fault code
arises if the water in the drum is not below a predetermined level when a
drain period has been completed in the wash program. It can be caused
by a blocked drain, blocked level hose, a water drop in the level hose, de-
fective level control, restricted drain lines to the machine, too many machi-
nes emptying simultaneously into drain pipes that are too narrow, etc.
Action:
• First check the drain installation and that the waste water can flow fre-
ely out from the machine without any restrictions.
• Check the drain valve in the machine with regard to dirt.
• Blow through the level hose and check that it is not blocked and does
not contain any water.
• Check in the service program that the level control is working correctly.
Troubleshooting