Repairs - Electrolux W465H Service Manual

102

Repairs

Repair work on the machine should only be
done by specially trained personnel.
Motor replacement
Disassembly
1. Take down power from the machine.
2. Remove the rear cover.
3. Undo the bracket for the drain hose connec-
tor from the lower rear piece, then remove the
rear cover.
4. Undo the ground connection from the motor.
5. Remove the drive belt by pulling the belt
9
towards you while rotating the drum by hand.
6. Undo the motor cable from motor.
7. Lock the motor in place to avoid it from falling
when lifting it out.
8. Undo and remove the two motor mounting
bolts.
9. Lift out the motor.
10. Replace the sensor and magnet from the old
motor into the new one.
Assembly
1. Fit the new motor without locking the moun-
ting bolts.
2. Fit the drive belt and adjust the belt tension
with the tensioner on one side of the motor.
Se section Adjustments - Drive belt tension
for details.
Motor and motor control
9
Mounting bolt
Spacer
H – model
M och N – model
Motor cable
6662
Motor cable
6663