Electrolux W465H Service Manual page 53

SHOW MCU COM.
Select the SHOW MCU COM. row and press the
18
knob.
The display shows the status of the communica-
19
tion to and from the frequency control.
RESET MCU
Reset frequency control from the fault code by
20
selecting the RESET MCU row and pressing the
knob. The reset will take a few seconds.
The square which lights up to the right of the
menu bar indicates that there is a fault code in
the DLCU (Door lock control unit).
SHOW SINGLE
Select the SHOW SINGLE row and press the
knob. The display shows the status of the com-
munication to and from the slot meter.
For detailed information, please contact your
supplier.
SHOW COM. PORTS
Select the SHOW COM. PORTS row and press
the knob. Possible communication ports are
shown in the display. Select a port, then press
the knob to test that port. Note that the ports
"send" and "receive" must be strapped for the
test to work.
Program unit
18
*SERVICE*
01.06.00.00
RESET DLCU
SHOW MCU COM.
RESET MCU
SHOW SINGLE
SHOW COM.PORTS
WEIGHT CALIBRATION
19
MOTOR STATUS
FROM MOTOR 10000100
FROM MOTOR 000000CD
ACTUAL SPEED RPM
SET SPEED RPM
BACK=PRESS KNOB
20
*SERVICE*
01.07.00.00
SHOW MCU COM.
RESET MCU
SHOW SINGLE
SHOW COM.PORTS
WEIGHT CALIBRATION
MEASURE WEIGHT
53
6204
0
0
6204
6204