Advertisement
Available languages
Available languages
Important Notes to the Installer
1. Read a llinstructions contained i nthese installation
instructions before installing t hecooktop.
2. Remove a llpacking material before connecting the
electrical supply t othecooktop.
3. Observe allgoverning c odes a ndordinances.
4. Besure to leave t hese instructions withtheconsumer.
Important Note to the Consumer
Keep these instructions withyourowner's g uide forfuture
reference.
IMPORTANT
SAFETY
INSTRU
S
Be sure your cooktop is installed
and grounded
properly
by a quaJified installer
or service
technician.
These cooktops
must be electrically
grounded
in
accordance
with
locat codes or, in their absence,
with the Nationa!
Electrical Code ANSI/NFPA No.
70--latest
edition
in the United States, or with
CSA Standard
C22.1, Canadian
Electrical
Code, Part
1, in Canada.
The electrical
power
to the cooktop
must be shut off while
line connections are being
made. Faiture to do so coutd resutt in serious injury
or death.
Provide
Electrical
Connection
Install the junction box under the cabinet and run 120/
240 or 120/208 Volt, AC wire from the main circuit
panel. DO NOT connect the wire to the circuit panel at
this time.
Electrical
Requirements
Observe all governing
codes and tocaJ ordinances.
1.
A 3-wire or 4-wire single phase 120/240 or 120/208
Volt, 60 Hz AC only electrical supply is required on a
separate circuit fused on both sides of the line (time-
delay fuse or circuit breaker is recommended). DO
NOT fuse neutral. The fuse size must not exceed the
circuit rating of the appliance specified on the
nameplate.
2.
This unit can consume up to 7300W at 240Vat, a
circuit breaker of 40 Amp with wire gauge #8AWG
shall be used.
NOTE: Wire sizes and connections must conform with
the fuse size and rating of the appliance in accordance
with tile National Electrical Code ANSI/NFPA No. 70-
latest edition, or with CSA Standard C22.1, Canadian
Electrical Code, Part 1, and local codes and ordinances.
An extension
cord must
not
be used
with
this
appliance.
Such use may result
in a fire,
eJectricat
shock,
or other
personat
injury.
2.
The appliance should be connected to the fused
disconnect (or circuit breaker) box through flexible
armored or nonmetallic sheathed cable. The flexible
armored (.able extending from this appliance should
be connected directly to the grounded junction box.
Tile junction box should be located as shown in
Figure 2 with as much slack as possible remaining in
the cable between the box and the appliance, so it
(.an be moved if servicing is ever necessary.
3.
A suitable strain relief must be provided to attach
the flexible armored (.able to the junction box.
Electrical
Connection
Connect tile flexible armored cable that extends from
the surface unit to the junction box using a suitable
strain relief at tile point the armored cable enters the
junction box. Then make tile electrical connection as
described on next page.
Electrical
ground
is required
on this appliance.
This appliance is equipped with a copper conductor
flexible cable. If connection is made to aluminum house
wiring, use only special connectors which are approved
for joining copper and aluminum wires in accordance
with the National Electrical Code and local codes and
ordinances.
This appliance is manufactured with a frame connected
green (or bare copper) ground wire.
Advertisement
