Stairmaster 4000PT Owner's Manual page 13

3. Open the box you removed from the pedals and remove the external
power supply.
4. Connect the DC cable of the power supply to the power connector
near the bottom of the right side cover.
5. To reduce the hazard of electrical shock,place the power supply on
the floor in a location to avoid exposure to perspiration and near an
AC wall outlet. The power supply must rest on a solid surface like a
rubber mat or block of wood, do not place the power supply directly
on carpet.
6. Check to be sure that the input AC power rating marked on the power
supply matches the available power. If it does not, obtain the match
ing power supply from StairMaster
before proceeding any further.
TO REDUCE THE RISK OF ELECTRICAL SHOCK AND FIRE AND TO
PREVENT SEVERE DAMAGE TO THE MACHINE, USE ONLY THE POWER SUPPLY
APPROVED FOR USE WITH THIS EQUIPMENT. IN ADDITION,
7. Connect the AC power cord to the AC wall outlet. Refer to the
"Grounding Instructions" section if the AC wall outlet does not accept
a three-prong plug.
8. Watch the console. The console should display a software
revision code and then show "SELECT WORKOUT." If the console
does not, unplug the power supply and then plug it back in. If the
console still does not power up correctly, contact our Customer
Service Department. Refer to the Appendix for the appropriate phone
number.
9. The display "SELECT WORKOUT" tells you the machine is ready to
use.
INSTALLATION INSTRUCTIONS
!
WARNING
YOUR MACHINE MUST BE PROPERLY GROUNDED.
®
Health & Fitness Products, Inc.
Page 5