Table of Contents
Advertisement
3-12. CLEANING
PROCEDURES
(Continued)
3-13. HALOGEN LAMP
REPLACEMENT
3-10
5.
Loosen the thumb screw on the blower fan blade and pull
blade from shaft. Then take fan blade to a sink to clean
thoroughly.
When reinstalling fan blade, be sure the offset shaft
matches up, and the thumb screw is tightened snug, but
not too tight. If the fan is not installed properly, the fan
could hit the vent cover and damage to the fan could
result.
Do not use abrasive cleaners or cleaners/sanitizers con-
taining clorine, bromine, iodine, or ammonia chemicals.
These abrasives and chemicals will deteriorate the
stainless steel material and shorten the life of the unit.
Do not use a water jet (pressure sprayer) to clean the
unit, or component damage could result.
Do not use any abrasive cloth, degreaser, oven cleaner,
or any type of corrosive cleanser when cleaning the
coated parts. Hot soapy water is all that is needed to
clean these parts. Any of the other cleaners mentioned
above will greatly reduce the life of the coating.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
Light bulbs and surrounding surfaces may be hot.
Severe burns could result.
1.
Push in and twist bulb counterclockwise to remove defective
bulb.
2.
Use the foam packing around new bulb, and push new bulb into
socket. Twist clockwise to lock into place.
When installing the new bulb, DO NOT touch light bulb with
fingers. Wrap the foam packing around bulb to install the
bulb. Failure to follow these instructions could cause dam-
age to bulb.
3.
Restore power to unit.
SCR-6/8
303
Hide quick links:
Advertisement
Table of Contents
