Installing The Air Baffle; Heat Sinks; Removing The Heat Sink - Dell PowerEdge C6220 Hardware Owner's Manual

Installing the Air Baffle

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Replace the two air baffles into the system-board assembly. Make sure
that the hooks are properly engaged with the heat sink bases. See
Figure 3-10.
2 Replace the system-board assembly. See "Installing a System-Board
Assembly" on page 143.

Heat Sinks

Removing the Heat Sink

CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
NOTE: Please place the foolproof pins of two processor heatsinks facing inside.
1 Remove the system-board assembly. See "Removing a System-Board
Assembly" on page 142.
WARNING: The heat sink may be hot to touch for some time after the system has
been powered down. Allow the heat sink to cool before removing it.
CAUTION: Never remove the heat sink from a processor unless you intend to
remove the processor. The heat sink is necessary to maintain proper thermal
conditions.
Installing System Components | 145