Dell PowerEdge C6220 Hardware Owner's Manual page 102

Token Setup option
Embedded
0137
SATA Controller
Embedded
0138
SATA Controller
Embedded
0139
SATA Controller
Memory
013E
Remapping
(3GB~4GB)
Memory
013F
Remapping
(3GB~4GB)
Execute-Disable
0140
(XD) Bit
Capability
Execute-Disable
0141
(XD) Bit
Capability
Virtualization
014A
Technology
Virtualization
014B
Technology
External USB
014E
PORT1
External USB
014F
PORT1
Max CPUID
0168
Value Limit
102 | Installing System Components
Description
Enables the SATA controller. Sets the device class code as
IDE and uses PCI IRQ (referred as Native mode). This
token applies to the first on-board SATA controller.
Enables the SATA controller. Sets the device class code as
SATA and sets up the AHCI BARs and registers. This
token applies to the first on-board SATA controller.
Enables the SATA controller. Sets the device class code as
RAID and executes the RAID Option ROM. This token
applies to the first on-board SATA controller.
Memory remapping relocates memory space behind PCI
hole to the space above 4G with this feature disabled.
Memory remapping relocates memory space 3G~4G to
the space above 4G with this feature enabled.
When disabled, Intel processors that support the
eXecute Disable (XD) feature will not report the
support to the operating system.
When enabled, Intel processors that support the eXecute
Disable (XD) feature will report the support to the
operating system. If the operating system supports this
extended paging mechanism, it will provide some
protection against software viruses that exploit buffer
overflows.
This feature will allow the users to disable the VT
technology in applicable processors. If disabled, the VT
feature is unusable in any OS.
This feature will allow the users to enable the VT
technology in applicable processors.
This feature will allow the users to electrically disable the
external USB port1.
This feature will allow the users to electrically enable the
external USB port1.
Some OS's (NT4) will fail if the value returned in EAX
is > 3 when CPUID instruction is executed with EAX=0.
This setting disables the 3 or less.