Impex MWM 2001 Owner's Manual page 12

STEP 7 (See Diagram 7)
A.) Connect the Chain (#40) to the end of Upper Cable. (See How to Use). Attach Clip (#49) to
the Chain. Then connect the Lat Bar (#17) to the Clip.
B.) Insert two Foam Roll Tubes (#48) halfway into the holes located on the Leg Developer (#10).
Slide four Foam Rolls (#51) onto the tubes and covered the end with four Foam Roll End
Caps (#52).
C.) Connect the Chain (#40) to the Lower Cable (#39). (See How to Use). Connect the Clip
(#49) to the Chain (#40). Then Connect Curl Bar (#18) to the Clip (#49). Remove the Chain
and Curl Bar when using the Leg Developer.
D.) Attach the AB Strap (#42) to the Cable Connector (#64) above the Backrest Pad.
DIAGRAM 7
11