Impex MWM 2001 Owner's Manual page 6

STEP 2 (See Diagram 2)
A.) Attach the Vertical Frame (#16) to the Lower Main Frame (#14). Secure it with two M10 x
2 ¾" Carriage Bolts (#69),
the Lower Main Frame (#14). Secure it from the front of Lower Main Frame (#14) with one M10
x 2 ½" Carriage Bolt (#70), one
B.) Attach the Short Pivot Support Bars (#6) to the pivot located on the back of the Vertical Frame
(#16). Align the holes and Insert a M12 x 6 ½" Short Pivot Axle (#33) through the holes. Secure
them with two
C.) Insert a 4 ½" Axle (#29) into the T-shaped Cable Connector (#15). Place the T-shaped Cable
Connector in between the two Short Pivot Support Bars (#6). Both ends of the Axle should fit
into the holes on the Support Bars.
D.) Attach the back end of the Short Pivot Support Bars (#6) to the holes on the top of the Main
Base Frame (#1). Align the holes and insert another M12 x 6 ½" Short Pivot Axle (#33).
Secure them with two
two Cone-shaped End Caps (#67).
E.) Secure the two nuts installed in Step B above. Cover both ends with two Cone-shaped End
Caps (#67). NOTE: DO NOT over-tighten the nuts on these pivots.
7/8" Washers (#82), and M10 Aircraft Nuts (#77) from the side of
7/8" Washer (#82) and M10 Aircraft Nut (#77).
1" Washers (#79) and M12 Aircraft Nuts (#36). DO NOT tighten the nuts yet.
1" Washers (#79) and M12 Aircraft Nuts (#36). Cover both ends with
5
DIAGRAM 2