Advertisement
7.
Turn on the connected equipment and verify the UPS does not go into
overload using the front panel LED indicator. SEE TABLE BELOW.
Condition
AC Mode
Battery Mode
Defective Battery
or Overcharging
Overload
Low Battery Cut
Off
1. Output receptacles
2. N/A
3. Communications port
4. Phone/Modem surge protection
5. AC input power cord
Input fuse
6.
1. Turning The MLP UPS On and Off
All MLP models will automatically turn on when the input plug is plugged in. To
turn the UPS off press the On/Off button located on the UPS front panel for five
seconds. To turn the UPS on again press the On/Off button for five seconds.
2. DC Start
To start the UPS when AC utility power is not available, press and hold down the
On/Off button for five seconds.
3. Green Power Function
All MLP UPS models are equipped with a Green Power function. If no load is
present at the UPS output receptacles (no equipment connected or equipment
turned off) the UPS will shutdown within two minutes. Should the utility AC be
loas during the shutdown, the UPS will automatically restart and again shutdown
after another two minutes on no load being applied.
4. Charging
Green
Orange
REAR PANEL LAYOUT
OPERATION
LED
Red
Audible
Alarm
None
Advertisement
