Introduction - Oceanic DataMax Pro Owner's Manual

#
#
DEPTH FT
DEPTH FT
SURFACE
SURFACE
T
I
M
E
T PSI
PSI
A
N
K
0 500 3000
DataMax
®
PRO
a.
Fig. 1 – Surface Mode
2

INTRODUCTION

The DataMax Pro was designed to be extremely easy to use and under-
stand. This owner's guide is divided into five sections designed to make it
easy to learn how to use the "Pro." The first two sections will show you how
the Pro performs in most typical diving situations. Section three shows how
it will perform under extreme conditions like deep or decompression diving.
Sections four and five present care & maintenance procedures and reference
material. Start here to begin learning about the DataMax Pro.
A
S
REGULATOR ATTACHMENT
C
E
Because the DataMax Pro is an "Air-Integrated" diving computer, it must
N
T
be attached to your regulator before you attempt to operate or use it. It is
best that this installation be performed by an Authorized Oceanic Dealer at
the time of purchase. If this is not possible, refer to the instructions for this
procedure on page 52.
4000
ACTIVATING THE DISPLAY
®
After installing the Pro onto your regulator, connect to a full scuba
cylinder. Turn on the tank valve to pressurize the system and activate the
computer by pressing the button under its display (Fig. 1a). Once the Pro
goes through a diagnostic check, it will enter "Surface Mode."