Station Speed Dialing - Comdial Solo II 5432S User Manual

Feature Operation
line preference is busy or unavailable, press a line key
and make the auto dial selection again.
To program numbers,
Press ITCM.
Press SAVE. Listen for tone.
Press desired key (in memory key field) for
autodial ltc&ons l-20 (level 1). Tone will stop.
s
Press HOLD key, then memory key for auto dial
locations 21-40 (level 2).
If specific line is to be used, press that line key.
Dial number sequence to be stored (up to 32
digits).
l
Press dial pad to store digits 1-9, 0, #, and ++.
l
Press HOLD to store pause if required.
l
Press TAP to store hookswitch flash if re-
quired.
Press SAVE and repeat procedure from auto dial
key selection for each number to be stored.
Press MONITOR to end programming.
Record level 1 autodial ID on the index card and
record level 2 autodial ID on the pull-out directory.
STATION SPEED DIALING
To speed dial numbers,
l
Press desired keypad key for speed dial locations
1-9, & 0. (If on line listening to dial tone, press
HOLD key and then dial desired keypad key 1-9,
& 0.
NOTE: Refer to the note given in the Automatic Dialing
discussion concerning automatic line choice by the
station.
To program numbers,
l
Following same steps given for Automatic Dialing
using the keypad keys 1-9, & 0 as speed dial
locations.
l
Record speed dial ID on station pull-out directory.
5