Arm Assembly - LIFESTYLER System 200 User Manual

m 5
5. Press the Weight Tube Bumper (64) into the
end of the Weight Tube (63). Insert the Weight
Tube into the stack of Weignrs (25). Be sure
that the pins on the Weight Tube ere sitting
In the pin grooves in the top Weight.
Lubricate the inside of the holes in the Top
Weight (76). Set the Top Weight onto the
stack of Weights (25).
Insert both Weight Guides (62) Into the stack
of Weights (25). Be sure that the holes in
the Weight Guides are at the top, as
shown.
.
Attach the upper ends of the Weight Guides
(62) to the Top Frame (55) with the 5/16" x 6""
Bolt (60), two 1/2" x 3/4" Spacers (61), and a
5/16" Nylon Locknut (3).
Be sure that the Pulley Bracket (20) is In
front of the right Weight Guide (62) as
shown.
,
Press a 1" x 7/8" Plastic Bushing (75) onto
each welded spacer on the Press Frame (17).
Slide the Press Frame into place on the Base
(4). Note:This will be a tight flLThe l"x
7/8" Plastic Bushings should fit on each
end of the Indicated tube In the Base. Be
sure that the 3 1/2" Pulleys (15) are on the
Indicated side.
Lubdcats the 3/8" x 8" Bolt (59). Attach the
Press Frame (17) to the Base (4) with the 3/8"
x 8" Bolt and a 3/8" Nylon Locknut (21),
6
7
>62
/
Lubdcate _
25
4
75
Welded
Spacers
7