Table of Contents
Advertisement
2.
Slide the Front Updght (42) onto the 5/16" x
2 1/2, Cardage Bolts (1) in the Base (4).
Hand-tighten a 5/16" Nylon Locknut (3) onto
each Carriage BOlL Do not tlghtan the Nylon
Locknuts yeL
Press a 1" Square Inner Cap (65) Into the
Front Updght (42).
Press 1" Round Inner Cap (49) Into each end
of the Foot Rest (83). Attach the Foot Rest to
the Rear Updght (56) with a 5/16" x 2 3/4" Bolt
(11), two 5/16" Washers (8), a 1/2,x 1/2,
Bushing (87), and a 5/16" Nylon Locknut (3).
Q
,
Press a 2" Square Inner Cap (27) into the Indi-
cated end of the Top Frame (55). Press a I 3/4"
Square Inner Cap (44) into each end of the
crossbar on the Top Frame. Press two 1"
Round Inner Caps (49) into the top of the
crossbar.
Attach the Top Frame (55) to the Front Up_ght
(42) and the Rear Updght (56) with four 5/16"
x 2 3/4" Bolts (t 1), four 5/16" Rat Washers (8),
and four 5/16" Nylon Locknuts (3).
Tighten all Nylon Locknuts used In steps 1
through 3.
Set two WelghtBumpers(19) onto the indicat-
ed bracketon the Base (4) as shown.
Stack eight Weights (25) onto the Weight
Bumpers (19). Be sure that the pin grooves
are all on the Indicated side.
2
65
49
Pin
4
6
Advertisement
Table of Contents
