Table of Contents
Advertisement
29, Press a 1,1/2" Square Inner Cap (32) Into the
Seat Frame (36).
Insert the 1/4" x 2" Carriage B01t(38) through
the center hole in the Seat Plate (37). Attach
the Seat Plate to the Seat (13) with two 1/4"x
1/2" Screws (18).
Insert the !/4" x 2" Carriage Bolt (38) through
the Indicated hole In the Seat Frame (36).
Tighten a 1/4" Nylon Locknut (2) with a 1/4=
Rat Washer (10) onto the'Carriage Boll
Attach'the other end of the Seat (13) to the
Seat _e_(3S)
With e 1/4" RaGWasher (10)
and a l/4'_:_2"screw
(24).
"
_
30, Lubricate the 5/16" x 2 1/4" Bolt (33), Attach
the Leg Lever (29) to the Seat Frame (36)
with the 5/16" x 2 1/4" Bolt and a 5/16 = Nylon
Locknut (3).
31. Attach the Short Cable (35) tO one of the
three holes in the Leg Lever (29) with a 5/16"
x 3/4" Bolt (89), a 5/16" Washer (8), and a
5/!6" Nylon Locknut (3). Note:The three
holes ere for Cable adjustment. Insert the
Short Cable between the welded red and the
Leg Lever.,
Press a 1" Round Inner Cap (49) into each
end of the Cud Bar (86); SUde the 5/8" x 3/8"
Bushing (91), the Curl Bar, and the Short
Cable (35) onto the 5/16" x 1 I/4" Carriage
Bolt (90). Hand-tighten a 5/16" Nylon Locknut
(3) onto the Carriage BoIL
32. Rest the Seat Frame (36)on the indicated pin
in the Front Upright (42). Attach the Seat
Frame to the Front Upright with a 5/16" x
2 3/4" Cardage Bolt (14) and the Seat Knob
(40).
29
36
32
24
10
2
J_--3
--29
31
49
49"
86
36
"1,4
Advertisement
Table of Contents
