Advertisement
THINGS TO CHECK BEFORE YOU START TO INSTALL
• PARTS IN THE SHIPPING CARTON -- Unpack
the carton carefolly so needed parts are not discard-
ed by mistake. Included are:
JO
i
_ WATER
Ill
, SUPPLY
RO
_.O
_"
WATER
SUPPLY
J
_
BATTERY
HOLDER
WITH
BATTERIES
(4).
l/
ELECTRONIC
FAUCET
TOP COVER
I
=WATER
PAUC_-'T
DRAIN
I
CLAMP
ASSEMBLY
f
I
• WATER SUPPLY raThe
cold water supply to
your Home Ddnking Water System must be within
certain chemical limits (see page 17). If not; It will
•not make product water as it should, and life of the
. RO membrane is.shortened. Trained salespeople
at Sears can arrange for a free water analysis. This
analysis will tell you if the water needs other treat-
ment before it goes into the Home Drinking Water
System.
filter carbon cartddge removes chlodne from the
water before it enters the RO membrane.
IMPORTANT:
TO
KEEP
CHLORINE
FROM
DESTROYING
THE RO MEMBRANE, BE SURE
TO REPLACE THIS CHLORINE REMOVAL CAR-
TRIDGE AT LEAST EVERY 6 MONTHS, OR 900
GALLONS. (SEE RO CARE GUIDE; PAGE 16.)
CAUTION: CHLORINE IN WATER SUPPLY. The
RO membrane is destroyed by chlorine. A pre-
• WHERE TO MOUNT THE RO ASSEMBLY AND
LOCATE THE STORAGE TANK
The Home Ddnking Water System fits nicely under
the kitchen or bathroom sink. However, you can in-
stall it where most handy for you. You do need a
COLD water supply pipe and drain point within 6
feet. Where speoe is limited, you can lay it on a shelf
or floor. Locate the assembly so you can easily get
to It to change filters.
The RO System weighs about 40 Ibs. when foil of
water. Set It on the floor or other solid surface that
will hold this weight.
! HOME DRINKING
WATER SYSTEM
.(S!NK TRAP)
.
ASSEMBLY
4
Advertisement
