Advertisement
HOW TO INSTALL YOUR HOME DRINKING
WATER SYSTEM
MAKE REMAINING RO CONNECTIONS - continued
B. CONNECT
TUBING,
FAUCET
TO DRAIN
CLAMP. Looking at FIG. 7, run the 3/8" x 27" tub-
ing from the RO faucet, to the drain clamp at the
sink p-trap. THIS MUST BE A STRAIGHT RUN,
WITHOUT DIPS, LOOPS, OR LOWSPOTS. Fasten
tubing, at the drain clamp, with a 3/8" hex nut.
C. CONNECT TUBING TO WATER SUPPLY
Use the tubing insert, ferrule and nut, at the water
supply saddle valve, to fasten the remaining 1/4"
tubing (marked "WATER SUPPLY"). Tighten the
nut with a wrench.
D. Fasten the faucet base and electronic box lead-
wire connectors together, routing where dry, and
out of the way.
I
STEP 5
--
SANITIZING,
PRESSURE
TESTING,
PLACING
IN "SERVICE"
A. DO THE SANITIZING PROCEDURES,
PAGE
15. THEN, CONTINUE WITH STEP B.
B. Double check all tubing connections to be Sure
they are tightened.
C. Open the house main water supply valve and
the supply saddle valve (turn handle fullyout_.Open
•the tank shutoff valve.., see below.
D. In about 4 hours, pressure w II start tobuild n
continued on next page
FAUCET
DRAIN CLAMP
P-TRAP
DRAIN
3/8"n tubing,
, ,
by 2T' long
HOT WATER
SUPPLY ,SADDLEVALVE
COLD WATER
TANK
SHUTOFF VALVE
tet_irler
RO
ASSEMBLY
10
CLOSED
leadwire COnnection
Advertisement
