Bowflex Xtreme 2 SE Assembly Manual page 18

step 17 Cable and Pulley Routing – Connect Pulleys and Cables to the Lat Pulley
Housing
Locate the following items for the Lat Pulley Housing assembly:
• (2) Pulleys from step 16
• 3/8" X 4 1/2" Hex Head Bolt – uninstalled in Step 16
• 3/8" Washer – uninstalled in Step 16
note:
Connecting the Cables is much easier with a second persn assisting you .
17-1
Holding both Cables from Step 16 in place, align the 2 Lat Pulleys as shown in Figure 17 . Slide the Pulleys
back into the Lat Pulley Housing, lining up the bolt holes in the Pulleys and Lat Pulley Housing.
17-2
Place the Washer over the 4 1/2" Bolt from Step 16. Slide the Bolt through the aligned holes in the Lat Pulley
Housing and Lat Pulleys as shown in Figure 17 .
Tighten all hardware.
note:
You will probably need to push the Power Rod
not pictured for the sake of clarity.
16
Bowflex Xtreme 2 SE Assembly Manual
®
Assembly Guide
2
1
unit out of the way for this step. The Power Rod
®
2
1
unit is
®