Finishing; Mantel Projections; Facing Material - Heat & Glo 6000G Owner's Manual

11 11

Finishing

A. Mantel Projections
Figure 11.1 shows the minimum vertical and correspond-
ing maximum horizontal dimensions of appliance mantels
or other combustible projections above the top front edge
of the appliance.
Note: All
measurements
in inches.
5
4
3
2-1/2
5
Note: Measurement is taken from top of the
opening, NOT the top of the fi replace.
Figure 11.1 Clearances to mantels or other combustibles
above appliance
IN T E R IO R W A L L
To p V ie w
A
F IR E P L A C E
O P E N I N G
M A N T E L L E G O R W A L L P R O J E C T IO N S
A
If minimum is ____, then
2-7/16 3-7/16 4-7/16 5-7/16 6-7/16 7-7/16
Inches
A
62 87
Millimeters
1 2
Inches
B
25 51
Millimeters
Figure 11.2 Mantel leg or Wall projections
(Acceptable on both sides of opening.)
B. Facing Material
WARNING
Fire Risk.
Do NOT obstruct air inlet or outlet grilles.
Do NOT modify grilles.
• Modifying or covering grilles could cause
temperature rise and fi re hazard.
Finishing materials must not interfere with:
• Air fl ow through grilles or louvers.
• Operation of louvers or doors.
• Access for service.
TO CEILING
18
12
11
10
32
9
8 25
7
19
6
18
17
16
15
14
13
12
11
10
MEASUREMENTS FROM
TOP EDGE OF THE OPENING
B
B
maximum is_____.
113 138 164 189
∞
3 4 5
∞
76 102 127
Heat & Glo • 6000G, 6000G-IPI • 2103-900 Rev. M • 9/08
NON-COMBUSTIBLE ZONE (Shaded areas)
41 in.
Figure 11.3 Noncombustible Facing
WARNING
Risk of Fire
• Non-combustible clearances MUST be
maintained.
• Sheetrock, wood or other combustibles must
NOT be used as sheathing or facing in the
non-combustible zone.
• See Section 11 for proper clearances.
• See Section 1 for combustible/non-
combustible defi nitions.
WARNING
Fire Risk.
Finish all edges and fronts to clearances and
specifi cations listed in manual.
• Do NOT overlap combustible materials onto appliance
front. The appliance front may only be covered with
noncombustible materials. The bottom one inch of the
appliance front is exempt and may be covered with either
non-combustible or combustible materials.
• Install combustible materials only up to specified
clearances on top, front and side.
• Seal joints between the fi nished wall and appliance top
and sides using only a 300º F minimum sealant.
39-3/8 in.
41