Heat & Glo 6000G Owner's Manual page 45

2 2
Figure 12.6 Front View
STEP 4.
Log #2 (SRV2103-108):
that goes over the tab molded into the top of log #1. The left end sits behind the simulated ember cluster on the burner top.
3 3
Figure 12.8 Front View
STEP 5.
Log #3 (SRV2103-110):
the log has a square groove cut through it. The groove sits over the second grate tine from the left. Slide it back against the
hump.
Figure 12. 10 Front View
STEP 6.
Log #4 (SRV2103-109):
slot in it that goes over the tab molded into the top of log #1. The other end of the log rests on the grate, against the second
tine from the right.
Figure 12.12 Front View
STEP 7.
Log #5 (SRV2103-111):
the center tine on the grate. The log shouldn't cover any ports.
Place log #2 on top of the left side of log #1. The bottom of this log has a slot in it
Place log #3 on top of the burner surface in front of the hump. The bottom of
4 4
Place log #4 on top of the right side of log #1. The bottom of this log has a
5 5
Place log #5 in front of log #3 the notch in the bottom of this log rests over
Heat & Glo • 6000G, 6000G-IPI • 2103-900 Rev. M • 9/08
2 2
Figure 12.7 Top View
3 3
Figure 12.9 Top View
Figure 12. 11 Top View
Figure 12.13 Top View
4 4
5 5
45