Getting Started; Connecting The Control Unit; Connecting The Ac Power Cable - Yamaha Disklavier E3 Operation Manual

Getting Started

Chapter
2

Connecting the Control Unit

Make sure that the cables extending from the piano is connected to the
appropriate connectors or jacks on the rear panel of the control unit.
*2

Connecting the AC Power Cable

1
Connect the power cord extending from the power supply unit
of the piano to the DC-IN 12V connector of the control unit.
2
Connect the AC power cable extending from the piano to
the AC wall outlet.
*1
Note:
The cables should be connected to
the control unit when the Disklavier
is installed. If, however, it is not,
carefully connect them to the
appropriate connectors or jacks on
the rear panel of the control unit.
Note:
For grand piano models, be sure to
mount the control unit to the
underside of the bass side key bed.
*1
Only for models supplied with
the monitor speakers.
*2
Only for models equipped with
the Silent Piano™ function.
Important:
Make sure that the voltage of the AC
wall outlet matches that marked on
the Disklavier's Serial No. plate.
9