Navigation Page - Standard Horizon CP180 Owner's Manual

3. Move the ShuttlePoint knob up or down to select the desired item within the groups
Marine Settings, Depth Settings, Land Settings, Chart Settings or Underwater Settings
and press [ENT]. See the above sections for details on selections.
12.2

NAVIGATION PAGE

This page is useful to show information when heading to a destination, following a compass
heading or navigating to a Mark or a Route. The default page is shown with a Compass
Rose, however this can be customized to show a Compass Tape.
1. To change to show the Compass Tape, select the Chart page, press [MENU]. Move the
ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight WINDOW SETUP and press [ENT] and press
[ENT] or move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight NAVIGATION PAGE and press [ENT] and
press [ENT] or move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint up or down to select COMPASS TAPE and press [ENT].
6. Press [CLR] or move the ShuttlePoint knob to the right until the Chart page is shown.
1
Fix position
2
Time
3 Speed Over Ground
4
Course Over Ground
5
Bearing to Destination
6
Time To Go
7
Distance to Destination
8
Compass Rose
1
Fix position
2
Compass Tape
3
Time
4
Time To Go
5
Speed Over Ground
6
Distance to Destination
7
Course Over Ground
8
Bearing to Destination
GPS Chart Plotters
1
2
3
4
5
6
7
Figure 12.2 - Navigation page with Compass Rose
1
2
3
4
Figure 12.2a - Navigation page with Compass Tape
WAAS 3D
WAAS 3D
Page 95
R
8
5
6
7
8