Cursor And Menu Selection Speed; Changing The Ship Icon - Standard Horizon CP180 Owner's Manual

mode. Now as the ship moves through the water the vessels position will be kept in the
center of the display.
To change from Cursor mode to Home mode press [CLR].
3.1.2

Cursor and Menu selection speed

The GPS Chart Plotter allows you to control the speed the Cursor moves when the
ShuttlePoint knob is pressed. To change the speed:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight CURSOR SPEED and press [ENT] or move the
ShuttlePoint knob to the right.
4. The menu now shows two selections, CHART and MENU which allows the Cursor
Speed to be selected to High, Medium or Low on Chart page or within the menus.
5. With CHART or MENU selected, press [ENT] or move the ShuttlePoint knob to the right.
Move the ShuttlePoint knob to the desired setting and press [ENT] or move the
ShuttlePoint knob to the right.
6. Press [CLR] until the menu disappears or an easier method is to press the ShuttlePoint
knob to the left a few times.
7. Move the cursor on the Chart page and see if the speed is to your liking.
3.1.3

Changing the Ship Icon

The cursor may be changed to any of the following:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
Page 32
NOTE
Figure 3.1.2 - Cursor Speed menu
Figure 3.1.3 - Ship icons
GPS Chart Plotters
R