Creating A New Mark With The User Points List - Standard Horizon CP180 Owner's Manual

The SEND and RECEIVE functions are used to receive or transmit User Points (Marks and
Waypoints) to and from a Personal Computer (see also Par. 2.10).
7.3

CREATING A NEW MARK WITH THE USER POINTS LIST

This function is very useful if you have a list of Marks that you want to enter into the GPS Chart
Plotter.
1. Press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press [ENT].
2. Move the ShuttlePoint knob to highlight MARKS/WPTS and press [ENT].
3. The MARKS/WAYPOINTS List page will be shown (see previous Figure).
4. To create a New Mark, move the ShuttlePoint knob to the right to highlight NEW MARK
and press [ENT].
5. Press [ENT] to change to show the Icon popup window.
6. Move the ShuttlePoint knob to highlight the desired Icon and press [ENT].
7. Move the ShuttlePoint knob to the right to select the Mark name. Press [ENT] and the
first digit in the name will be highlighted.
8. Move the ShuttlePoint knob up or down to select the first character.
9. Move the ShuttlePoint knob to the right to select the next character.
10. Repeat steps 8 and 9 until the Mark name is shown. Press [ENT].
11. Move the ShuttlePoint knob to the right to select the Lat/Lon and press [ENT].
12. Move the ShuttlePoint knob up or down to select the first character.
13. Move the ShuttlePoint knob to the right to select the next character.
14. Repeat steps 12 and 13 until the desired position is shown. Press [ENT] and [CLR], a
WARNING "Save the new Mark?" popup window will be shown, move the ShuttlePoint
knob to the right or left to select YES or NO and press [ENT].
After entering in all the Marks it is a good practice to back up the points to a C-CARD. Refer to
Section 11.
Page 66
NOTE**
Figure 7.2 -Example of Marks/Waypoints List
NOTE
NOTE
GPS Chart Plotters
R