Table of Contents
Advertisement
INSTALLATION AND SETUP
Composite Video
The video decoder input panel provides simultaneous connection of both a composite video
source (INPUT 3) and an S-Video source (INPUT 4).
If connecting a composite video source, use the Composite BNC connector or the RCA phono
jack at -do not use both as inputs. See Figure 2.13.
AUDIO for INPUT 3: To control audio levels in an audio/visual system, connect pre-amplified
(line level) audio inputs to the "IN 3" left and right channel audio inputs located near the top
left corner of the rear input panel. Then connect external audio amplification equipment to
audio "OUT" for sound output. Audio connection cables require standard RCA type phono
plugs.
NOTE: If you want to loop a composite video signal through to another projector or display
device, see Video Loop Through later in this section.
Figure 2.13. Connecting Composite Video
2-14
Advertisement
Table of Contents
