Using Inputs And Channels - Runco Reflection VX-5c Owner's Operating Manual

OPERATION
NOTE: Press
Editing Numerical Values
Enter numbers directly from the keypad in order to specify numbers representing projectors,
channels (source setups), switchers, or slots. As each digit is entered, it is displayed and the
cursor moves on. Note that channel numbers are defined with 2 digits-for example, if you enter
only a single digit (like "7") for a channel number, the channel will automatically be defined as
"07". Use "07" to utilize this channel.
NOTES: 1) Once you enter the first digit, this digit replaces all old digits. 2) If you press any
non-numbered key, the number entered up to that point is accepted and updated as the new
value. 3) Press
3.5

Using Inputs and Channels

NOTE: See Section 2, Installation and Setup, for a full explanation of how to connect a variety
of sources to the projector.
The projector stores and automatically recalls up to 99 different channels (source setups) for a
variety of inputs. This memory feature allows you to define and conveniently use a wide variety
of customized setups rather than having to repeatedly re-configure the projector for different
presentations. Each physical source (i.e., input) can have several different channels associated
with it.
Selecting an Input
INPUT - An input simply describes a physical location for an incoming signal connection.
These connections are always either on the projector itself (one of the four inputs at the rear of
the projector).
Pressing the appropriate direct key -
display from one of the four inputs connected at the rear of the projector.
If it is the first time you have used the source/input (or if you used the input but did not define
a channel by adjusting anything ), the projector will recognize the new input signal based on its
frequencies and polarities, and will automatically display an image according to default settings
for such a signal. Note that a graphic source will resize into a full-screen image, whereas video
or HDTV sources will resize only as much as possible while maintaining their aspect ratio.
If you used the source once before and changed a display parameter such as contrast, V-
Position etc., then a channel was automatically created and still exists in projector memory (see
below). Using an
and update the display accordingly.
If more than one channel exists for the input, the image will be displayed according to the
setup parameters for the first channel with matching characteristics.
at any time to cancel changes and return to the previously-defined text.
Exit
to cancel editing of numerical values.
Exit
EXAMPLE:
` = use source connected to the projector, slot #1 (i.e.,
Input
0 1
key will automatically recall this channel-and all its setup parameters-
Input
, , , or
Input1 Input1 Input1
Input1
3-14
- is a quick and seamless way to
)
Input1