Using Inputs And Memory Banks - Runco Video Xtreme VX-4c Owner's Operating Manual

OPERATION
NOTE: Press
Editing Numerical Values
Enter numbers directly from the keypad in order to specify numbers representing projectors,
Memory Banks (source setups), switchers, or slots. As each digit is entered, it is displayed and the
cursor moves on. Note that Memory Bank numbers are defined with 2 digits-for example, if you
enter only a single digit (like "7") for a Memory Bank number, the Memory Bank will automati-
cally be defined as "07". Use "07" to utilize this Memory Bank.
NOTE: 1) Once you enter the first digit, this digit replaces all old digits. 2) If you press any non-
numbered key, the number entered up to that point is accepted and updated as the new value.
3) Press
3.5

Using Inputs and Memory Banks

NOTE: See Section 2, Installation and Setup, for a full explanation of how to connect a variety
of sources to the projector.
The projector stores and automatically recalls up to 99 different Memory Banks (source setups)
for a variety of inputs. This memory feature allows you to define and conveniently use a wide
variety of customized setups rather than having to repeatedly re-configure the projector for dif-
ferent presentations. Each physical source (i.e., input) can have several different Memory Banks
associated with it.
Selecting an Input
INPUT - An input simply describes a physical location for an incoming signal connection.
These connections are always either on the projector itself (one of the four inputs at the rear of
the projector).
Pressing the appropriate direct key -
display from one of the four inputs connected at the rear of the projector.
If it is the first time you have used the source/input (or if you used the input but did not define
a Memory Bank by adjusting anything ), the projector will recognize the new input signal based
on its frequencies and polarities, and will automatically display an image according to default set-
tings for such a signal. Note that a graphic source will resize into a full-screen image, whereas
video or HDTV sources will resize only as much as possible while maintaining their aspect ratio.
If you used the source once before and changed a display parameter such as contrast, V-Shift
etc., then a Memory Bank was automatically created and still exists in projector memory (see
below). Using an
eters - and update the display accordingly.
If more than one Memory Bank exists for the input, the image will be displayed according to
the setup parameters for the first Memory Bank with matching characteristics.
at any time to cancel changes and return to the previously-defined text.
Exit
to cancel editing of numerical values.
Exit
EXAMPLE:
`
Input
0
key will automatically recall this Memory Bank - and all its setup param-
Input
= use source connected to the projector, slot #1 (i.e.,
1
, , , or
Input1 Input1 Input1
3-13
- is a quick and seamless way to
Input1
)
Input1