Position The Fireplace (I80 Only) - Heatilator I60 Owner's Manual

• Remove smoke shield by removing fi ve screws. See
Figure 7.3. Smoke shield is located at top of fi replace
front.
• Remove screens by removing screw from the end of
each screen rod. See Figure 7.4.
Front Face
Skip
Remove these screws.
Figure 7.3 Removing Smoke Shield
Figure 7.4 Removing the Screen Rods
• Remove hearth stone by removing three corrugated
shipping spacers (Figure 7.5). Lift hearth stone out of
fi replace. See Figure 7.6.
Figure 7.5 Shipping Spacers
Figure 7.6 Lifting Out the Hearth Stone
22
Smoke Shield
Skip
Heatilator • I60, I80 • 4013-250 • Rev C • 11/08
WARNING! Risk of Fire! Prevent contact with sagging,
loose insulation.
• DO NOT install against vapor barriers or exposed
insulation.
• Secure insulation and vapor barriers.
• Provide minimum air space clearances at the sides
and back of the fireplace assembly as outlined in
Section 6.
• Remove fi replace from pallet.
The fi replace is attached to pallet with two brackets on
each side and rear of outer shell. See Figure 7.7.
• Remove screws from bracket, pallet and fireplace.
Replace screws removed from fi replace.
Figure 7.7 Removing Shipping Brackets
E. Position the Fireplace (I80 only)
• Place the fi replace on a continuous fl at surface.
• Follow framing instructions in Section 6.
• Slide fi replace into position (brackets can be used to
anchor fi replace in position).
Note: Before installing refractories and hearth stone, be
sure all back edges of each piece are smooth to ensure
proper fi t.
Scrape away excess with a regular screwdriver. See
Figure 7.8.
Figure 7.8 Scrape Away Rough Edges