Storing Your Settings (Customize) - Roland C-330 Owner's Manual

6.
Press the [SET] piston.
The Factory Reset will be executed.
If you decide to cancel, press the [Value/Exit Menu] knob.
Do not turn off the power while the following screen is
displayed.
fig.D-Factory-Reset.eps
When the Factory Reset has been completed, the following screen
will appear.
fig.D-Factory-Reset.eps
7.
Turn the power off, then on again.
When you perform a factory reset, the settings that were
stored at the general memory pistons will also return to their
factory-set state. Be sure that general memory piston settings
you want to keep have been copied to USB memory (p. 49)
before you proceed.

Storing your settings (Customize)

You can store the following settings so that they will be retained
even while the power is turned off.
Settings
Default Voice Palette*
"User/MIDI coupler" screen settings
"Room Modeling" screen settings
"Console" screen settings (except for V-LINK)
"Tremulant" screen settings
"Exp. Pedal" screen settings
"Audio" screen settings
Satellite Volume settings (included in Audio)
"MIDI" screen settings (except for Local ON/OFF)
* What is the Default Voice Palette?
This contains information that specifies which of the four sounds in
each voice palette will be selected when you turn on that tablet
immediately after turning on the power. (This does not remember
which tablet is turned on; rather, which sound will be selected when
a tablet is turned on.)
You can use the voice palette to select and store your favorite
variation sound for each tablet.
Subsequently, even if you've turned off the power, your
favorite variation sound will be selected when you press that
tablet. This will save you the trouble of selecting the desired
variation sound from within each voice tablet.
Information as to which of the four sounds of the voice palette
is selected is also remembered by the general memory pistons.
This means that when you use a general memory piston to
recall a registration, the settings that were recalled by that
general memory piston will remain in effect until you turn off
the power.
The settings stored by the above operation store everything
concerning the state of the C-330.
If you want to store only a single setting, turn the power off,
then on again. Next, edit only the setting you want to store,
and perform step 1 below.
1.
Hold down the [SET] piston and press the [0] piston.
Confirmation screen will appear
fig.D-Factory-Reset.eps
2.
Press the [SET] piston to store the settings.
If you decide to cancel, press the [Value/Exit Menu] knob.
Other Settings
65