Other Commands; Dma Data Transfer Commands; Figure 5.6 Protocol For The Command Execution Without Data Transfer - Fujitsu MHW2080AT Product Manual

Figure 5.6 Protocol for the command execution without data transfer

5.4.4 Other commands

•
READ MULTIPLE (EXT)
•
WRITE MULTIPLE (EXT/FUA EXT)
•
SLEEP
See the description of each command.

5.4.5 DMA data transfer commands

•
READ DMA (EXT)
•
WRITE DMA (EXT/FUA EXT)
•
INDENTIFY DEVICE DMA
Starting the DMA transfer command is the same as the READ SECTOR(S) or
WRITE SECTOR(S) command except the point that the host initializes the DMA
channel preceding the command issuance.
Interruption processing for DMA transfer does not issue interruptions in any
intermediate sector when a multisector command is executed.
The following outlines the protocol:
The interrupt processing for the DMA transfer differs the following point.
• The interrupt processing for the DMA transfer differs the following point.
a) The host writes any parameters to the Features, Sector Count, Sector Number,
Cylinder, and Device/Head register.
b) The host initializes the DMA channel
c) The host writes a command code in the Command register.
d) The device sets the BSY bit of the Status register.
e) The device asserts the DMARQ signal after completing the preparation of
data transfer. The device asserts either the BSY bit or DRQ bit during DMA
data transfer.
C141-E250
5.4 Command Protocol
5-135