Table of Contents
Advertisement
SUPERSERVER 6017TR-TQF/TFF/TF User's Manual
5-2
Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard.
Connecting Data Cables
The cables used to transfer data from the peripheral devices have been carefully
routed in preconfi gured systems to prevent them from blocking the fl ow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are confi guring the system, keep the airfl ow in mind when routing the cables.
The following cables need to be connected for the SuperServer 6017TR-TQF/TFF/TF
system:
•
Two round 50-cm 16-to-16-pin ribbon front control cables (CBL-0087)
•
One set of SATA 4-51/47/41/37-cm round cables (CBL-0201L)
•
Two 4-pin 20-cm power cables (CBL-0212L)
5-3
Control Panel Connectors and I/O Ports
The rear I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-1 below for the colors and locations of the various I/O ports.
3
1
4
2
Figure 5-1. Rear I/O Ports
5
6
7
5-2
8
9
Advertisement
Table of Contents
