Table of Contents
Advertisement
5-5
Installing Memory
Caution: Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots, starting with
DIMM 1A. For best memory performance, please install memory modules
of the same type and same speed on the memory slots as indicated on the
tables below.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules.
To Install: Insert
module vertically and
press down until it
snaps into place. Pay
attention to the align-
ment notch at the
bottom.
To Remove: Use
your thumbs to gen-
tly push the release
tabs near both ends
of the module. This
should release it from
the slot.
Note: 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size memory modules are sup-
ported. It is highly recommended that you remove the power cord from the system
before installing or changing memory modules. Please refer to our web site for
memory that has been tested on the H8DGU(-F) serverboard.
Figure 5-3. Installing DIMM into Slot
Notch
Release Tab
5-7
Chapter 5: Advanced Serverboard Setup
Front View
Note: Notch should align with
the receptive key point on
the slot.
Top View of DDR3 Slot
Notch
Release Tab
Advertisement
Table of Contents
