Heat & Glo CFL-18LP-C Owner's Manual page 8

• If a remote control is used, the receiver cannot
be placed under the burner. If possible, place the
receiver outside the combustion chamber.
• If the receiver must be placed in the combustion
chamber, the protective heat shield MUST be used.
See Figure 5.
Figure 5. Protective Heat Shield
• Position receiver on left side of gas log set (opposite
the pilot). Place protective heat shield over receiver.
See Figure 5.
Figure 6. Receiver Location-Left Side of Log Set
8
Heat & Glo • CFL-18/24/30-C, CFL-24-IPI, ST-CFL-24-B • 526-910 Rev. E • 10/08