4. Note the orientation of the socket cover, and install one side of the socket cover into the microprocessor
socket.
Figure 51. Installing one side of the socket cover into the microprocessor socket
Note: Your microprocessor socket and cover might look slightly different from the illustration.
5. Carefully press the other side of the socket cover downward until the socket cover snaps into position.
6. Carefully check the four corners of the socket cover to make sure that the cover is secured in the
microprocessor socket.
7. Follow any additional instructions included with the replacement part you received.
Replacing the hard disk drive bracket
Attention: Do not open your computer or attempt any repair before reading and understanding the "Important
safety information" on page 1.
This section provides instructions on how to replace the hard disk drive bracket.
To replace the hard disk drive bracket, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 77.
3. Locate the hard disk drive. See "Locating FRUs and CRUs" on page 69.
4. Disconnect the signal cable and the power cable from the hard disk drive.
.
Chapter 9
Replacing FRUs
107