IBM Brocade FCoE Installation And User Manual page 11

•
Never turn on any equipment when there is evidence of fire, water, or
structural damage.
•
Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
•
Connect and disconnect cables as described in the following table
when installing, moving, or opening covers on this product or attached
devices.
To Connect:
1. Turn everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors..
4. Attach power cords to outlet.
5. Turn device ON
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM
battery recommended by the manufacturer. If your system has a module containing a lithium
battery, replace it with only the same module type made by the same manufacturer. The battery
contains lithium and can explode if not properly used, handled, or disposed of.
Do not:
•
Throw or immerse into water
•
Heat to more than 100° C (212° F)
•
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Statement 3:
To Disconnect:
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from
connectors.
4. Remove all cables from devices.
®
Part Number 33F8354 or an equivalent type
xi