Table of Contents
Advertisement
5 Turn the selector to 0, and wait till the blades come to a stop, before removing the lid from
the jug, or removing the jug from the motor unit.
6 Don't use the blender unless the lid is in place.
7 Don't fill with anything hotter than you can comfortably handle (i.e. liquid temperature
below 40°C).
8 When blending hot liquids, put a hand on the lid to hold it in place.
9 Don't put your hand into the jug, even after you've removed it from the motor unit – the
blades are sharp.
10 Take great care when handling the jug base and blades.
11 Don't put any other object (spoon, spatula, etc.) into the jug while the blender is plugged in.
12 Don't leave the blender unattended while plugged in.
13 Sit the motor unit on a dry, firm, level surface, near a power socket.
14 Route the cable so it doesn't overhang, and can't be tripped over or caught.
15 Don't let the jug overflow. If liquid gets under the motor unit, it may be sucked into the motor,
damaging it.
16 Don't fill the jug above the 1.8 litre mark – if you do, the contents may force the lid off when
you start the motor.
17 Don't run the motor for more than one minute at a time, then leave it for a minute to cool
down before using it again.
18 Don't run the blender empty, it may overheat.
19 Keep the blender and the cable away from hotplates, hobs or burners.
20 Don't fit any attachment or accessory other than those we supply.
21 Don't use the blender for any purpose other than those described in these instructions.
22 Don't operate the blender if it's damaged or malfunctions.
23 If the cable is damaged, return the blender, to avoid hazard.
before using for the first time
Turn to "care & maintenance" on page 5, and clean the blender and attachments thoroughly, to
remove manufacturing dust, etc.
preparation
1 Sit the motor unit on a dry, stable, level surface, out of reach of children.
2 Route the cable so it doesn't overhang, and can't be tripped over or caught.
3 Sit the jug on the motor unit.
, In normal use, you should treat the jug and jug base as a single unit. They should only be
separated when you come to clean them.
4 Lift the lid off the jug.
5 You'll find it's quite stiff (it has be, to keep the ingredients from escaping when you turn the
motor on).
6 Put the ingredients into the jug.
7 Don't fill past the 1.8 litre mark. If you do, the contents may force the lid off when you start
the motor.
fit the lid
8 Put the lid on the jug, and press it down.
9 Don't use the blender without fitting the lid. The contents may escape; you may hurt
someone; you may be tempted to put a hand into the jug.
10 Align the pips on the sides of the cap with the slots in the hole in the lid, put the cap into the
hole, and turn it anti-clockwise to lock it into the lid.
11 Don't run the motor without fitting the cap. If you leave it open, solid ingredients may be
ejected through the hole when they hit the blades.
household use only
3
Advertisement
Table of Contents
