Stomp Loop; A-E Footswitches; Amp Loop; Expression Pedal - DigiTech iPB-10 Owner's Manual

iPB-10 Top Panel iPB-10 Top Panel

Stomp Loop

This footswitch enables and disables the
mono stompbox effects loop. The LED
lights when the stomp loop is enabled.

Amp Loop

This footswitch enables and disables the
amp loop. The LED lights when the amp
loop is enabled.
Status messages will be displayed if the AMP or STOMP footswitches are pressed and the Amp or Stomp Loop
NOTE:
modules are not used in the current preset Tone (unavailable), or if nothing is connected to these jacks (not connected).

A-E Footswitches

Use these footswitches to turn the assigned effect pedals on
and off. When a pedal is active, it's footswitch LED will light.

Expression Pedal

This pedal provides
real-time control of
Volume, Wah, or any
other assigned effect
parameter. Rock the
pedal forward and
press firmly to toggle
between controlling
the Wah and the other
assigned parameter.
When using the
NOTE:
Expression Pedal, the Wah
will only be controlled if it
exists in the effects chain.
18