Working With Amps; Adding An Amp To The Ipb-10 Signal Path - DigiTech iPB-10 Owner's Manual

Working With Amps

Working With Amps

Adding an Amp to the iPB-10 Signal Path

1. If the Pedalboard window is not already active, select
it by touching the Pedalboard icon.
2. Touch the Edit button to display the Edit screen.
3. Touch the icon located in the amp field. A window
will appear displaying all the available internal amps.
4. Select the desired amplifier from the list. The matching
cabinet will be loaded with the amp.
5. Touch the Done button.
6. To position where the amp is located in the signal
path, touch the Amp icon and drag it to the desired
position (this will also set the signal path location of
the Amp Loop, if used).
7. Once complete, touch the Performance button to get
back to Performance mode.
1.
3.
4.
6.
2.
5.
7.
33