Configuring The Amp Loop - DigiTech iPB-10 Owner's Manual

Assigning Footswitches Assigning Footswitches

Configuring the Amp Loop

1. If the Pedalboard window is not already active, select
it by touching the Pedalboard icon.
2. Touch the Edit button to display the Edit screen.
3. If there is no amplifier assigned, touch the
located in the amp field. If there is already an amp
assigned, jump to step 6.
4. Select an amplifier from the list. The matching cabinet
will be loaded with the amp.
5. Touch the Done button.
6. To position where the amp is located in the signal
path, touch the Amp icon and drag it to the desired
position (this will also set the signal path location of
the Amp Loop).
7. Once complete, touch the Performance button to get
back to Performance mode.
8. Press the AMP LOOP footswitch to engage and
disengage the Amp Loop. When this footswitch LED is
on, the Amp Loop is enabled and the connected device
is inserted into the iPB-10 signal path replacing the
internal amp.
If enabled, the Amp Loop connection remains active when a tone is bypassed.
NOTE:
1.
icon
4.
3.
6.
8.
2.
5.
7.
38