Daewoo DWD-WD1353WC Owner's Manual page 18

2. DELAY WASH
Put the laundry into the Drum and check the detergent and softener levels.
1
(refer to page 10)
Then close the Door.
Press the Power button.
• The LED shows only '- --' signal.
2
Note
Select the program using the program selection dial.
• If you press 'Start/Pause' button after pressing Power button the washer will default
to the normal cycle, if you have not selected a different wash cycle.
• If you want to change any of the following 'Water Temperature', 'Soil Level', 'Washing
3
Cycle', 'Rinse Time(s)' or 'Spin Speed', select the program you want to change by
pressing its corresponding button.
• If you want to use bleach, press 'Bleach' button.The bleach will be automatically
dispensed at the proper time during the wash cycle.
Press the 'Delay Wash' button.
• The 'Delay Wash' indicator light will turn on.
4
• Select the delay time you want from 1 hour to 12 hours by pressing button.
• The finishing time will be indicated on the display.
Press the 'Start/Pause' button.
5
• If the cycle has been successfully programmed the Delay Wash and Lock indicators
will light.
Note :
•
If you want to review the selected program,press the 'Start/Pause' button again.
•
Preparing washer before starting 'Delay Wash'.
- Turn on the water tap.
- Load laundry and close Door.
- Place the detergent and fabric softener in the detergent case if needed.
•
The actual finishing time may vary do to water temperature and water supply conditions.
•
'Gym Shoes', 'Delicate', 'Drum Cleaning' and 'Steam Spray' program are not programmable 'Delay Wash'.
•
Adding clothes during 'Delay Wash' operation is not allowed.
: If one or all of the detergent dispensers are low, the low detergent indicator
will light and the beeper will sound.
18