Table of Contents
Advertisement
User Tools (System Settings)
Settings You Can Change with the User
Tools
For details on how to display the settings, see P.13 .
General Features 1/3
2
Fusing Adjustment: Paper Tray
Specifies the characteristics of the paper roll in the paper tray. If the image on
copies is scratched, or the paper wrinkles when using translucent paper (vel-
lum), you can change the setting to get better copies.
You can specify separate settings for Plain, Translucent paper (vellum), and Film.
Note
Default: 3
The paper thickness can be set from 1 (Thicker) to 5 (Thinner).
Refer to the chart below when selecting the mode for the paper thickness.
Mode
Paper Type
Plain paper
Translucent
paper (vel-
lum)
Film
*1
Out of guarantee
Depending on the type of paper and the operating conditions, the toner
fusing condition changes. To improve the toner fusing change the mode
setting to 3 2 1.
When using thin paper, or soft, limp paper, the toner fusing may be wrin-
kled or the image may be blurred. In these cases, change the setting to
mode 3 4 5.
When using Film, do not set to mode 5.
When Translucent Paper modes 1 or 2 are selected, and you change the pa-
per type from Plain or Film to Translucent Paper, it may take longer for the
machine to get ready for copying. (Up to two minutes).
16
1
2
2
2
110g/m
90g/m
(23.9
(29.3 lb)
lb)
2
70 – 90g/m
70 – 80g/m
(18.6 – 29.3
(18.6 – 21.3
lb)
lb)
* If the paper wrinkles when using mode 3,
try using mode 2 or mode 1.
0.07mm –
0.07mm –
0.095mm (2.8
0.095mm (2.8
Mil – 3.7 Mil)
Mil – 3.7 Mil)
3
4
2
70g/m
(Stan-
60g/m
dard mode)
lb)
(18.6 lb)
2
2
70 – 80g/m
50 – 70g/m
(18.6 – 21.3
(13.3 – 18.6
lb)(Standard
lb)
mode)
0.07mm –
0.07mm –
0.095mm (2.8
0.095mm (2.8
Mil – 3.7 Mil)
Mil – 3.7 Mil)
(Standard
(Standard
mode)
mode)
5
2
2
(15.9
50g/m
(13.3
lb)
2
2
50-60 g/m
(13.3-15.9 lb)
*1
—
Advertisement
Table of Contents
