Table of Contents
Advertisement
9. Have another person hold the Console (17) near the
Upright (2).
Connect the Upper Wire Harness (95) to the wire har-
ness on the Console (17). Connect the Pulse
Extension Wire (101) to the pulse wire on the Console.
Next, locate the two ground wires that are attached to
the Upright (2). Connect the ground wires to the two
smallest wires on the Console.
Carefully insert all excess wiring up into the Console
(17) and down into the Upright (2). Attach the Console
to the Upright with four M4 x 16mm Screws (98).
(Note: The Screws may be found in the console box.)
Be careful to avoid pinching the wires.
10. Plug the Power Cord (93) into the Power Socket (92)
at the rear of the elliptical exerciser.
11. Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the
elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left after assembly is
completed.
9
Do not pinch
the wires
during this step.
101
98
98
10
9
17
95
Ground
Wires
2
92
93
Advertisement
Table of Contents
