Healthrider HRE99940 User Manual page 7

5. Apply a small amount of grease to the axle on the Left
Crank Arm (34).
Identify the Left Pedal Leg (4), which is marked with
an "L" sticker. Slide the Left Pedal Leg onto the axle
on the Left Crank Arm (34). (Note: It may be helpful to
use a rubber mallet to tap the Left Pedal Leg on. Do
not to confuse the Left Pedal Leg with the Right
Pedal Leg [not shown].) Attach the Left Pedal Leg
with an M8 x 19mm Patch Screw (111), an M8 Washer
(66), and a Torque Washer (113).
Attach the Right Pedal Leg (not shown) in the same
way.
See the inset drawing. Identify the Left Pedal (10),
which is marked with an "L" sticker. Attach the Left
Pedal to the Left Pedal Leg (4) with two M6 x 48mm
Flat Head Screws (83). Note: The Left Pedal can be
attached in any of three positions using the three sets
of holes in the Left Pedal Leg.
Attach the Right Pedal (not shown) to the Right
Pedal Leg (not shown) in the same way.
6. Hold a Pedal Wheel (28) inside of the bracket on one
of the Upper Body Legs (31). Hold the Upper Body
Leg and the Pedal Wheel inside of the bracket on the
Left Pedal Leg (4). Slide a Pedal Leg Cover (33) onto
the long side of an M8 x 63mm Bolt Set (65), and
insert the Bolt Set into the Left Pedal Leg, the Upper
Body Leg, and the Pedal Wheel.
Slide a Pedal Leg Cover (33) onto the short side of the
M8 x 63mm Bolt Set (65) and tighten it into the long
side of the Bolt Set.
Attach the other Upper Body Leg (not shown) and
the other Pedal Wheel (not shown) to the other
side of the elliptical exerciser in the same way.
5
113
66
111
6
31
4
33
65
7
Grease
34
4
83
10
4
65
33
28