Reinstall The Doors - KitchenAid BOTTOM MOUNT REFRIGERATOR Use And Care Manual

7. At the bottom, right-hand side of the cabinet, remove the
plastic cover and the hinge. Unscrew the leveler, and using the
hex key, remove the front and bottom hinge screws.
NOTE: You may need to use a flat-edged tool to pry the
plastic cover from the hinge.
8. Move the bottom hinge and the foot to the opposite sides of
the cabinet.
9. Using the hex key, place the hex screws into the holes of the
bottom hinge and fasten the hinge to the cabinet. Replace the
plastic cover and reinstall the leveler. See Bottom Hinge
graphic.
10. Using the hex key, place the hex screws into the foot holes
and fasten the foot to the cabinet. Replace the plastic cover
and reinstall the leveler.
A. Plastic cover
B. Bottom hinge
Doors
Refrigerator Door
1. Move the hole plug from the top of the refrigerator door to the
opposite side. See Graphic 2.
B
A. Door hinge hole plug
2. Using a Phillips screwdriver, remove and discard the door stop
from the bottom of the refrigerator door. Set aside door stop
screw.
3. Insert a door stop, from the Reversibility Kit, into the holes in
the bottom, left-hand side of the refrigerator door. Fasten with
the screw removed in Step 2. See Graphic 3.
A
B
A. Door stop (remove and discard)
B. Door stop screw
8
A
B
C
D
C. Leveler
D. Hinge screws
A
B. Bushing
C
C. Door stop (Reversibility Kit)
Freezer Door
1. Move the hole plug from the top of the freezer door to the
opposite side. See Graphic 4.
2. Using a Phillips screwdriver, remove and discard the door stop
from the bottom of the freezer door. Set aside door stop
screw.
3. Insert a door stop, from the Reversibility Kit, into the holes in
the bottom, left-hand side of the freezer door. Fasten with the
screw removed in Step 2. See Graphic 3.
A
B
A. Door stop (remove and discard)
B. Door stop screw

Reinstall the Doors

Freezer Door
1. Set the freezer door onto the bottom hinge pin.
2. Move the bushing from the top of the center hinge pin to the
bottom of the center hinge pin. Insert the hinge pin into the
top of the freezer door.
3. Using the hex key, and the two internal hex head screws,
removed earlier, install the center hinge to the left-hand side of
the cabinet.
4. Insert two hole plugs, from the Reversibility Kit, into the holes
remaining after the removal of the center hinge. See
Graphic 5.
A
B
C
A. Center hinge pin
B. Bushing
C
D
C. Hole plug
D. Door stop (Reversibility Kit)
C. Internal hex head screws
D. Hole plugs (Reversibility Kit)
D