Assembly - Healthrider Momentum 831.285770 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the HEALTHRIDER
remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver
rubber mallet
1. Make sure that there are Stabilizer Endcaps (27) on
the ends of both Stabilizers (30).
Hold one of the Stabilizers (30) against the saddle on
the front of the Base (1). Make sure that the Stabilizer
is turned so the square holes are facing away from the
Base. Attach the Stabilizer with two 3/8Ó Carriage Bolts
(28) and two 3/8Ó Nylon Locknuts (29).
2. Hold the other Stabilizer (30) against the saddle on the
rear of the Base (1). Make sure that the Stabilizer is
turned so the square holes are facing away from the
Base. Attach the Stabilizer with two 3/8Ó Carriage Bolts
(28) and two 3/8Ó Nylon Locknuts (29).
3. Refer to the inset drawing. Feed the console wire
harness down into the Upright (3), until the end of the
console wire harness extends from the lower end of
the Upright.
While another person holds the Upright (3), connect
the console wire harness to the Main Wire Harness
(39). If the wire harnesses do not fit together easily,
turn themÑdo not force them together. After you
have connected the wire harnesses, pull any slack
in the wire harnesses up through the Upright.
Slide the Upright (3) onto the welded bolts on the
Base (1). Be careful to avoid pinching the wire
harnesses. Tighten a 3/8Ó Nylon Locknut (29) onto
each welded bolt.
.
¨ MOMENTUM in a cleared area and
, two adjustable wrenches
1
28
27
2
29
3
29
Console
Wire
Harness
39
5
, and a
29
27
1
30
1
30
28
3
Console
Wire
29
Harness
3
1